Technical Data
Product Information
| Item information | Value |
|---|---|
| HAN: | DAA-MBF-DROPPER |
| Category: | Geschosszuführung |
DAA
Mr. Bulletfeeder Dropper Assembly
The dropper die is the "clever" heart of the feeder: it lets exactly one bullet drop per press stroke and retains the rest of the column. As a separate part it enables a second, pre-adjusted toolhead – for example for a quick change between 9 mm and.38 Super or between two bullets.
The dropper die is the calibre-specific heart of the feeding system. It releases exactly one bullet and retains the following bullets.
The die is adjusted in the station following the powder measure. It only taps the bullet lightly into the prepared case and does not replace a seating die. Tighten the lock nut by hand or very lightly.
The manuals present the Mr. Bulletfeeder as a Double-Alpha Academy product ("by Double-Alpha"). The brand belongs to the reloading line of the Dutch outfitter from the IPSC world.
- Calibre specific
Each die is made for one calibre.
- Components
Threaded die body, inner aluminium dropper tube, nut, clip and three steel balls.
- For Mr. Bulletfeeder and Mini
The same die is used in both the Mr. Bulletfeeder and the Mini Mr. Bulletfeeder.
- Second toolhead
With one adjusted die per toolhead, there is no re-adjusting when changing over. For similar calibres (e.g. 9 mm and.38) the upper part can be moved from one die to the other.
- Steel balls by calibre
Per the Mini Mr. Bulletfeeder manual: 9/.38 uses 4.5 mm (0.18 in), 10/.40 uses 4.0 mm (0.16 in),.45 uses 3.5 mm (0.14 in).
Material and craftsmanship
Anodised aluminium (die and dropper tube), steel balls.
Scope of delivery
- Threaded die body
- Inner aluminium dropper tube
- Nut
- Clip
- 3 steel balls
Notes
- The die only taps the bullet lightly onto the case and does not replace a seating die.
- Tighten the lock nut by hand or lightly with a wrench; over-tightening can damage the aluminium body.
- Disassemble over a bowl, as the small steel balls fall out.
- A second toolhead usually needs an additional powder funnel for its powder measure.
- Reloading ammunition is inherently hazardous: read the complete manufacturer manual and always wear eye and ear protection.
* Firearms, optics, magazines, ammunition and accessories shown are not included unless expressly stated. The selected article variant applies.
DAA
