Technical Data
Product Information
| Item information | Value |
|---|---|
| HAN: | DAA-MINI-MR-BF |
| Category: | Geschosszuführung |
DAA
Mini Mr. Bulletfeeder
Automatically place bullets onto the case without putting your fingers under the tool head – reloading becomes faster, easier and safer. The Mini differs from the full Mr. Bulletfeeder by having no collator: you pre-load the bullet tubes by hand, which takes only two to three minutes for over 100 bullets.
The DAA Mini Mr. Bulletfeeder feeds bullets from a rotating six-tube magazine holding about 100 bullets in pistol calibres. When a tube is empty the magazine advances to the next position.
A free toolhead station directly after the powder measure is generally required. The dropper die is calibre specific.
Included: six-tube magazine, dropper die, three spare steel balls and instructions. Pistol versions also include a Dillon-compatible expanding powder funnel; rifle versions do not include a powder funnel.
The Mini Mr. Bulletfeeder is the more affordable sibling of the Mr. Bulletfeeder and comes from Double-Alpha Academy. It was developed to offer almost the same convenience at a much more accessible price.
- Six-tube magazine
Holds about 100 bullets in pistol calibres and 70 to 100 in the rifle versions, depending on calibre and bullet length. When a tube is empty you click the next one into place.
- Additional tube magazines
Additional tube magazines are available separately or as a bundle, allowing 300, 400 or more bullets to be pre-loaded, much like primer tubes.
- Calibre-specific dropper die
The dropper die places one bullet onto the case per press stroke; it is generally installed in the station following the powder measure.
- Progressive press compatibility
Usable on any progressive press that uses standard-size dies; for the rifle versions, Dillon-size dies are named. Designed for the Dillon powder drop.
- Easy installation
Quick and simple setup; the manufacturer's page offers video tutorials for setup, full assembly and calibre conversion.
Material and craftsmanship
Steel balls in the die, aluminium threaded die body, stainless steel powder funnel (per the manual; included with pistol calibres).
Scope of delivery
- Six-tube bullet magazine
- Dropper die assembly with three spare steel balls
- Expanding powder funnel, Dillon-compatible (pistol calibres only)
- Instruction sheet
Notes
- Rifle versions: no powder funnel is included because rifle brass cannot be sensibly expanded in it; flaring must be done as a prep step or with a modified M-die. On a Dillon 1050 the tubes must be shortened to fit beneath the case feeder.
- Designed for the Dillon powder drop; other presses may require a different funnel. A Hornady funnel is available on request at ordering or separately.
- The Dillon XL750 powder measure can interfere with stations 3 and 4; the manufacturer offers an extra-short Dillon powder bar for this. On a Dillon 1050 with a powder check in the following station, the angle of the powder dropper can cause difficulties.
- Ball size in the die depends on calibre: 9/.38 uses 4.5 mm (0.18 in), 10/.40 uses 4.0 mm (0.16 in),.45 uses 3.5 mm (0.14 in).
- Reloading ammunition is inherently hazardous: read the complete manufacturer manual and always wear eye and ear protection.
* Firearms, optics, magazines, ammunition and accessories shown are not included unless expressly stated. The selected article variant applies.
DAA
