HOGUE Hardwood Grip for S&W Revolver Round Butt
Lamo Camo Top Finger Groove Stripe/Cap Checkered
Looking for a unique fancy hardwood grip for your favorite revolver or autoloader? Take a look at Hogue’s Lamo Camo grip option. Made from 100%, flaw-free White Birch heartwood veneer, Lamo Camo is created using a state-of-the-art lamination process that ensures complete color penetration through every layer. It’s an eye-catching grip in alternating hues of light and dark dyed natural wood guaranteed to prompt fellow shooters to ask, “Where’d you get that grip?”
Please note: Due to the nature of wood and wood laminate, each Lamo Camo grip is unique in figure and color. The pictures above may not represent the grips that are in current inventory.
Fits the following Smith and Wesson J-Frame Round Butt models:
-38, 49, 317, 331, 337, 351PD, 360, 431PD, 437, 438, 631, 637, 638, 649, 650
-Fits the following Centennial Frames: 032, 042, 332, 340, 342, 432PD, 442, 632, 640, 642, 940
-and the following models are either Round or Square Butt: 30, 32, 33, 34, 36, 37, 43, 50, 51, 60, 63, 651
Will also fit the early I-Frame models.
To differentiate between Round and Square Butt, measure the flat area on the very bottom of your grip. This is the surface that commonly has the serial number located on it. Round Butts will measure around 1" and Square Butts will be over 1 1/4".
Does NOT fit Polymer Bodyguard models(BG38) except for models 60020, 60026, and 60027.
Does NOT fit model 40 and 42 due to grip safety and different dimensions on the grip Frame.
-Will NOT fit Charter Arms revolvers.(Undercover -3,; Pit Bull)
-Will NOT fit semi-auto "Chief Special", only revolver version.
-J frame revolvers hold 5(five) .38 caliber bullets in cylinder.
-Revolver often refered to as "chief special".
-See rubber grip model 61000 for Bantam design. It very compact and lightweight (1.4 ozs.). Backstrap and bottom straps are exposed. Patented Bantam grip snaps on with no metal fasteners.
Monogrip Features:
- Original one-piece design that hugs the frame - no inside screws or loose shifting panels.
- Hogue`s famous orthopedic hand fit.
- Designed to achieve the firearms`s optimum finger to trigger reach.
- Hand buffed carnauba wax finish - no hard sprayed-on finish to ckrack or peel off with use.
- Suitable for use with speedloaders
- for left and right-handers
- Design: Lamo Camo Top Finger Groove Stripe/Cap Checkered
- Delivery without gun!
- Manufacturer: HOGUE / USA
The unique one-piece design of Monogrip reguires that it be mounted from the bottom of the hand handle. Since the grip will not like conventional two piece designs, please read the mounting instructions included thoroughly.
Hogue`s exotic hardwood grips will reward you with improved scores and comfortable shooting for years to come.
No modofication to your gun is necessary to install the grip.
*Stock Pin Notes:
-Must replace standard 5/8" stock pin with shorter 1/2" pin on wood models only, the new pin is included with the grip. On some frames, the pin hole in the frame is a little on the large side. It is OK that the pin is a little loose. The grip will keep the pin in the frame and the tension created by the screw in the stirrup assembly will keep the pin from moving.
-Must be sure to center the stock pin if the grip will not start on frame or go on all the way.